Willbanks Metals
Willbanks Metals - Sheet, Plate, & Structural Steel Products

Structural Steel Rolling Services

Willbanks has the ability to roll angle, tubing, beam, flat bar, channel and pipe. WMI can provide a ‘one off’ part or ability to provide thousands of the same with repeatability in quality. We have hundreds of templates that allow us to save time and increase quality expectations for your angle rolling needs. Our two Structural rolls can provide small parts down to 1′ flat bar up to 6′ square tubing.

Small Roll:

  • 4½" x 4½" x ½" Angle "Leg Out" min. 50" diameter
  • 4" x 4" x ½" Angle "Leg In" min. 60" diameter
  • 1" x 4" Flat Bar Hardway min. 36" diameter
  • 1" x 8" Flat Bar Easyway min. 36" diameter
  • 4" square max/min diameter varies with wall thickness
  • Channel & Beam – 8" width max. varies with diameter
  • 4" Pipe min. 48" diameter
  • 4" square tubing

Large Roll:

  • 6" x 6" x ¾" Angle "Leg Out" min. 60" diameter
  • 5 x 5 x ¾" Angle "Leg In" min. 63" diameter
  • 1-1/2" x 7" Flat Bar Hardway min. 47" diameter
  • Channel & Beam-12" width max. varies with diameter
  • 8" Pipe min. 110" diameter
  • 6" square tubing

Ready to Take the Next Step?

Willbanks Metals is one of the nations largest general line steel service center in the southwest United States. We consider ourselves a ‘one stop shop’ for the consumer of steel products and fabrication services.

Contact Us Today